• Small size and low weight compared with traditional stacked lamination types.
• Extremely low level of radiated magnetic field
• Very low induced noise (hum)
• Very low iron loss.
• Double insulated primary leads.
• Supplied with mounting kit.
  
• 100% electrical and flash tested
  
• High quality manufacturing and testing in accordance to EN61558, EN60742, EN60950, EN60065, VDE0551, VDE0550 and BS415
• Tested and Approved by KEMA to EN61558. Click here for more info
• UL Recognised to UL506, under family approval file E215495

Important Installation Note
Each transformer is supplied with a dished washer and protection pads for single hole fixing. Ensure that the pads are fitted above and below the transformer winding and that the dished washer is on top of the upper pad. Do not overtighten the fixing bolt (not supplied) as this could damage the winding.
Under no circumstances should both ends of the fixing bolt contact a metal chassis or frame as this would create a 'shorted turn' causing irreparable damage.
The following data sheets are available as Adobe Acrobat PDF files.

	Rated VA	Part Number (xxx=Sec voltage)	Regulation % Typical	Temperature Rise [K]	Dimensions* Diameter [mm]	Height [mm]	Weight [Kg]
	15	0015P1-2-xxx	16	26	60	31	0.30
	30	0030P1-2-xxx	18	40	70	32	0.45
	50	0050P1-2-xxx	14	42	80	33	0.65
	80	0080P1-2-xxx	14	53	93	38	0.90
	120	0120P1-2-xxx	10	52	93	46	1.20
	160	0160P1-2-xxx	9	55	105	42	1.50
	225	0225P1-2-xxx	8	60	112	47	1.90
	300	0300P1-2-xxx	8	60	115	58	2.30
	500	0500P1-2-xxx	6	68	136	60	3.50
	625	0625P1-2-xxx	5	67	136	68	4.30
	800	0800P1-2-xxx	5	69	162	60	5.10
	1000	1000P1-2-xxx	5	72	162	70	6.50

• * Allow extra 4mm for mounting kit, allow extra 5mm where leads emerge
• Leads: PVC insulated 150mm long.
• Secondary voltage tolerance <1% at nominal input.
• UL recognised for Insulation Class A (105'C)
• Maximum ambient operating temperature +40'C
• Neoprene pads: 5kV isolation
• Meets all requirements of Class E (120'C)